V-Ray users

Comment

Comment by Majik Hudson on January 10, 2012 at 8:05pm

Also, if you get a pretty good handle on Vray for Rhino, a lot of that knowledge will serve you well in Vray for 3DS Max as well.

Comment by Carl Harrison on January 9, 2012 at 10:34am

Thank you for the advice. I will certainly act on it. Best regards.

Comment by Majik Hudson on December 24, 2011 at 8:57am

update, what I meant to say was I'm unaware of YOUR knowledge on the subject of render engines.

Comment by Majik Hudson on December 24, 2011 at 8:33am

To Carl Harrison, to answer your question on the grainy issue I would start at the primary and secondary engine settings, particularly your irradiance map settings. I'm unaware of the knowledge on the subject, but if you understand min/max sample then I would adjust those accordingly, especially with regards to your image resolution. There's a Vray for Rhino manual that goes into depth and should've been available with the install. Good luck 

Comment by Carl Harrison on December 9, 2011 at 1:18am

Have not had any replies to my question but I guess its a busy world out there.  Has anyone taken a look at the book on Vray for 3D Max yet? I wonder if it would be of any help to a rhino user even thought the controls are different.

Comment by Carl Harrison on November 18, 2011 at 1:45am

Hi there,

I have recently joined your site from the UK and am experimenting with Vray for Rhino. I need some help getting the resolution of my images better as when large the pictures appear grainy. I also am on the holy grail of wanting more reality in my images. Not much to ask then!

Carl Harrison

Comment by Sterling Vanderwerker on October 10, 2011 at 3:11pm

Hi folks.

 

Jewelry designer, retailer, pastor, redwings fan

Comment by Vince Johnson on August 31, 2011 at 9:54am

Hey everyone! A fellow V-Ray user has a question over in the forum.

 

http://www.rhinojungle.com/forum/topics/how-to-make-a-material-with...

Comment by Nate Ogdahl on April 21, 2011 at 9:19am

That's where I've run into trouble.  I have to sit there and hit the cancel button a few hundred times to save me a few hours.  One trick I've been using is to break my animations up into smaller individual scenes and then edit them together in adobe premiere or iMovie.

Comment by Roy Berntsen on April 21, 2011 at 6:54am

do you also know how to abort an animation? It seemes to continue when i close the render

• ‹ Previous
• 1
• 2
• 3
• Next ›
• Page